Select 110C-M2 Close Window
 Print Sheet


CLASSIFICATION: E110C-G per AWS A5.28, ASME SFA 5.28

Select 110C-M2 is designed for those applications where the slag residue and fume emissions of flux cored electrodes are unwanted. This composite metal cored electrode is formulated for single and multiple pass welding of low alloy steels, in the flat and horizontal positions, where a minimum tensile strength of 110,000 psi is required in the deposited weld metal.

APPLICATIONS: Select 110C-M2 is an ideal choice for joining low alloy, high strength steels such as HY-100 and A514. Earthmoving equipment, mining trucks and machinery and heavy equipment trailers are some areas where these steels may be utilized. Select 110C-M2 may also be used for overlay or surfacing in certain applications.

DIAMETERS: .035", .045", .052", 1/16"

SHIELDING GAS: 95-98% Ar/balance O2, 75-95% Ar/balance CO2, 35-50 cfh

WELDING POSITIONS: Flat and Horizontal

CHARACTERISTICS:

  • Exhibits superb welder appeal.
  • Arc transfer is a pure spray.
  • Virtually no spatter.
  • Higher deposition rates than solid wire.

    TYPICAL MECHANICAL PROPERTIES
     
    98% Ar/
    2%
    O2
    Ultimate Tensile Strength (psi) 115,600
    Yield Strength (psi) 106,400
    Percent Elongation 16
    CVN (ftlb f) @ -20° F 42
                      @ -60° F 28

    TYPICAL DEPOSIT COMPOSITION
    Wt% C Mn P S Si Ni Cr Mo
    .03 1.71 .010 .010 .42 2.00 .19 .55

    TYPICAL WELDING PARAMETERS: Metal Cored -- Argon/Oxygen
      Operating Range Optimum
    Diam. Amps
    (DCEP)
    WFS
    (in/min)
    Volts ESO Amps WFS Volts
    .035" 180-320 350-750 23-29 1/2-3/4" 200 550 25
    .045" 180-330 240-600 22-28 1/2-1" 255 410 26
    .052" 220-460 220-620 23-30 1/2-1" 300 350 26
    1/16" 230-520 160-500 22-31 3/4-1 1/4" 360 300 26

  •